Steam Turbine Advanced Sealing System

MD&A Parts Division’s Advanced Sealing system for steam turbines, consists of the Patented Guardian® & Vortex Shedder® Sealing Technology which improves steam turbine efficiency above design! View our new 3D video below and then call MD&A Parts Division today at (518) 885-3199 or use our Contact form.

Read More

Exhaust Temperature Spreads

WIBNISE Volume 1, Number 1: Exhaust Temperature Spreads What is an exhaust temperature spread, and why is it so important to monitor and take appropriate action when an exhaust temperature spread develops? An exhaust temperature spread refers to a high differential in readings between the thermocouples placed radially around the exhaust of a gas turbine. The worst […]

Read More

Diaphragm Dishing Repair

Mechanical Dynamics and Analysis inspected and repaired a stage 15 dished diaphragm. The unit was an upgraded 297.5 MW D6 frame unit. The stage 15 diaphragm was found to be dished downstream by approximately 0.215”. MD&A’s Turbine-Generator Repair Facility performed a dishing repair to the stage 15 diaphragm by cutting out the old weld, re-positioning, […]

Read More

MD&A Company Video

Mechanical Dynamics & Analysis is a steam & gas turbine and generator full service provider.  MD&A began in 1982 as a small engineering firm supporting power generation companies with third party consulting services.  Since its inception, MD&A has maintained an entrepreneurial culture and has focused on outstanding customer service. As a result, over 35 years later, […]

Read More

Rexroth® Hydraulic Actuator

MD&A Bearings, Seals & Hydraulics Division (MD&A) recently rebuilt a Rexroth® hydraulic actuator in less than 5 days which included providing new disc springs, servo, poppet valve and shaft. This level of service saved the owner weeks of forced outage downtime and revenue loss. During operation the owner observed erratic valve response and hydraulic fluid […]

Read More

A-10 Rotor Straightening & High Speed Balance

Mechanical Dynamics and Analysis inspected and repaired an A-10 frame High Pressure rotor.   The unit was a 3600 rpm, 90 MW combined cycle unit.  MD&A’s Turbine-Generator Repair Facility performed the incoming inspections / evaluations, repair straightening of the rotor, final inspections, as well as high speed balance. Incoming inspections and evaluation consisted of blast cleaning, […]

Read More

Tour of our new High Speed Balance facility!

Take a tour of our new High Speed Balance facility! Mechanical Dynamics & Analysis (MD&A) High Speed Balance Facility is one of the most modern balance facilities for power turbines in the United States.  It services rotors for generators, steam turbines, gas turbines, large motors, and boiler feed pump turbines.

Read More

Welcome

Welcome to Mechanical Dynamics and Analysis’ (MD&A) Resource Center! MD&A is one of the largest turbine-generator repair & turbine engineering organizations in the United States. We provide complete project management, overhaul and reconditioning of heavy rotating equipment worldwide. Our turbine engineering service teams of project managers, technical directors, shop personnel and consulting turbine-generator engineers are […]

Read More

HPU Pump Motors Are Continuously Running

PROBLEM DEFINITIONThe Hydraulic Power Unit (HPU) pump motors are continuously running at excessive current levels. DETAILMany Hydraulic Power Unit (HPU) pump motors have been observed to be running with excessive current while the turbine is at steady state operating conditions. This condition may also be accompanied by an inability to hold normal operating pressure of […]

Read More