Home
Value Added Service
Contact Us

Is your turbine MHC governor having difficulty accurately responding to a DCS or load following dispatch signal?

Would it make any sense to troubleshoot a turbine MHC governor in a test cell facility to correct long term problems and reduce the start up time of your next turbine outage?

MOTOR DRIVEN
SPEED/LOAD CHANGER UPGRADES OR COMPLETE PROGRAMMABLE REPLACEMENTS

VERIFICATION AND CALIBRATION ON MOTORIZED - HYDRAULIC TEST STAND

  • Speed/load change response regulation
  • High/low speed stop setting
  • Bobble diagnosis/correction
  • Pre-emergency operation
  • Hydraulic trip/reset
  • Auxiliary pilot valve overtravel
  • Hydraulic relay hysteresis
  • Flyweight characteristics

B1.jpg (3624 bytes)

B2.jpg (3530 bytes)
B3.jpg (6041 bytes)



Tapered Land Thrust Bearings || Hydrogen Seals || MHC Operating Governor || Steam Seal Regulators
Tilt Pad Thrust Bearings || Tilt Pad Journal Bearings || Control Rotor || Control Pac Power Actuator || Accessory Starting Equipment

is a division of

Renewal Parts Maintenance • 4485 Glenbrook Road • Willoughby, Ohio 44094
Telephone:(440)946-0082 • Fax:(440)946-5524 • Toll Free (800)446-4776